September 23, 2019Design principles for the runner system:1. For the single plastic part and multiple cavities, the balanced runner (except special) should be used, that is, the position of each cavity gate and the siz...view
March 15, 2024In the injection molding production process, temperature and humidity control of the mold are key factors that directly affect the quality and production efficiency of the product.view
April 21, 2020The engineer in charge needs to prepare DFM to check the mold structure in detail. If there is any doubt, it needs to be clarified on the spot. If there is something wrong, it needs to be recorded and...view
October 31, 2023Table of ContentsABS injection molding material propertiesApplication fields of ABS injection molding pelletsSteel selection for ABS injection moldABS injection molding process conditionsABS, commonly...view
November 11, 2021The development trend of steel that is used in European and American household appliances is carbon tool steel, low alloy tool steel, high alloy tool steel. A series of new mould materials have appear...view
January 31, 20231. The plastic product dimension is out of tolerance.Plastic part dimension exceeds the tolerance range (especially the appearance dimension), the reasons for dimension out of tolerance are as follows...view
Call us on: 
Email Us: 
1st Floor, Block1, No.3 Beiting Road, Houting Community, ShaJing Street, Bao'An District, Shenzhen City, Guangdong Province, China 
English
Deutsch
italiano
русский
français
română
العربية
Español
Polska
日本語
한국어