July 30, 2019The key point is design, good design comes to high yield production.Design level leads to lower costs and better efficiency.80% of the troubles found during mould trial and mass prodcution was due to ...view
April 21, 2020Plastic injection is a method in which a thermoplastic or thermosetting moulding compound is first uniformly plasticized in a heating barrel, and then pushed into the cavity of closed mould by a plung...view
June 17, 2021Rusting of plastic injection tooling is a common phenomenon. It not only affects the appearance of the mold, but also directly affects the overall quality of the mold. Therefore, mold rust is a proble...view
October 8, 20221. Cylinder temperature of injection plastic parts:The temperature of the melt is very important and the temperature of the injection cylinder used is only indicative. Glue temperature can be measured...view
December 17, 20201. The injection molding process of plastic mold is long, and the processing time is short. For injection molding parts, many of them are integrated with other parts and components. This is because of...view
October 28, 20191. Process analysis of plastic products.Before the die design, the designer should fully analyze whether plastic products conform to the principle of injection molding. It is necessary to consult with...view